MD-GLUE BS.406 bottle 20g
MD GLUE BS.406 low viscosity (approx. 3-10 mPa.s)
For bonding rubber, plastic, steel and metals as well as EPDM. Sticks lightning fast.
Hand strength: 2 - 10 seconds
Temperature resistance: -50°C to +80°C
Gap Filling Capacity: 0.05mm
- Economical in use
- Precise order possible
- Hand tight in a few seconds
- High impact resistance
- Silicone free
- Very high tensile strength
Application note:
The parts to be bonded must be clean and free of oil and grease. Apply a thin coat of superglue to one side and press the parts together. Depending on the type, the hand strength is reached in a few seconds, final strength after 24 hours. To accelerate curing, our MD ACTIVATOR CA NR. 9 are used. In the case of materials such as PP, PE, Teflon® or silicone, the parts must be pre-treated with MD PRIMER No. 7.